...
Air Pro Solutions co-founders Alec Smith and Efer Zamorano

Ductwork Replacement Cost: What to Budget for Your Auburn Home

TLDR

Table of Contents

Technician reviewing smart thermostat settings for a heat pump on a tablet

National guides put ductwork replacement cost at about $10 to $25 per linear foot, with whole-home jobs averaging around $4,000 and ranging from about $2,000 to $12,000. Crawl space work, common in Auburn, often costs more per foot. Size, access and materials set your price. Our full ductwork redesign service starts with an inspection, so you only replace what needs it.

Key Takeaways

  • Typical range: about $10 to $25 per linear foot installed, with many whole-home jobs between $2,000 and $12,000.
  • Crawl spaces cost more: tight access can push labor to $30 to $60 per linear foot.
  • Leaky ducts waste a lot: about 20 to 30 percent of air in a typical duct system is lost to leaks and poor connections.
  • Not every duct needs replacing. Sealing, repairs or a partial redesign can solve many problems for less.
  • Time it with new equipment. Replacing ducts during a heat pump or furnace install avoids paying for access twice.
Ductwork replacement cost check with an airflow test at a supply vent

How Much Does Ductwork Replacement Cost?

The Angi ductwork cost guide puts the average at about $4,000, with a typical range of $2,000 to $12,000. It lists $10 to $25 per linear foot for new ductwork, including materials and labor. These are national numbers. Your home’s layout and access matter more than the average.

Cost factorLower endHigher end
AccessOpen basement or garageTight crawl space or finished attic
ScopeA few damaged runsFull system, supply and return
MaterialInsulated flex ductRigid sheet metal with sealed joints
InsulationDucts inside heated spaceDucts in crawl space or attic needing insulation
Design workSame layout, new materialResized trunk, new returns, rebalanced runs
ExtrasNoneNew registers, wall or ceiling patching, asbestos testing on old systems

Why crawl spaces cost more

Many homes in Auburn, Kent, Covington and Bonney Lake have ducts under the floor in a crawl space. Crawl spaces are low, damp and tight. Work goes slower. The Angi crawl space guide puts these jobs at about $30 to $60 per linear foot, with an average near $4,800. Moisture barriers, rodent damage and sagging duct straps add work too.

Why Ductwork Matters So Much

Your ducts carry every bit of heated and cooled air in your home. If they leak, you pay to heat your crawl space or attic. The ENERGY STAR duct sealing page says that in a typical house, about 20 to 30 percent of the air moving through the duct system is lost to leaks, holes and poorly connected ducts.

In our damp climate, leaky return ducts in a crawl space can also pull musty, moist air into the house. That affects comfort and air quality, not just your energy bill.

Signs Your Ductwork Needs Repair or Replacement

  • Some rooms are always too hot or too cold
  • High energy bills that keep climbing
  • Weak airflow from certain vents
  • Dust that comes back fast after cleaning
  • Musty smells when the heat or AC turns on
  • Visible damage: crushed, torn, sagging or disconnected ducts in the crawl space or attic
  • Old fiberboard or uninsulated metal ducts from decades ago
  • New equipment that never felt right, often because the old ducts were sized for a different system

Is duct cleaning the answer?

Usually not, when the problem is leaks or poor design. The EPA duct cleaning guidance says cleaning may be worth it in some cases, such as visible mold or pests, but that it has not been shown to prevent health problems in general. Cleaning will not fix a crushed or leaky duct. See our air duct cleaning cost guide if cleaning is what you need.

Technician inspecting the air handler and duct connections

Repair, Seal or Replace?

Most homes do not need a full replacement. Here is how we usually decide.

What we findUsually the right fix
A few loose joints or small leaksSeal with mastic or foil tape
One crushed or torn runReplace that section
Rooms that never get enough airAdd or resize runs, add a return
Widespread damage, rodent nests or wet insulationReplace the affected system
Ducts sized for an old furnace, now feeding a new heat pumpRedesign and replace as needed

Heat pumps often need more airflow than old furnaces. Ducts sized decades ago can leave a new heat pump noisy, weak or inefficient. That is why we check ducts before any heat pump install.

Planning a new system? Call (253) 397-7220 and ask us to inspect the ducts during the same visit. Doing both at once can save you a second round of crawl space labor.

Ways to Keep Ductwork Costs Down

A good duct job is not cheap, but you can avoid paying more than you need to.

  • Inspect before you replace. Many homes only need sealing and a few new runs.
  • Bundle the work. If a new furnace or heat pump is coming within a year or two, do the ducts at the same time.
  • Fix the worst runs first. Crushed or disconnected ducts usually give the biggest comfort gain per dollar.
  • Clear the access path. A clean, open crawl space entry saves labor time.
  • Ask about utility programs. Some utilities offer duct sealing incentives. Check with your utility before work starts.

What Happens During a Ductwork Replacement

  1. Inspection: we look at every accessible run, check for leaks and damage, and note the duct sizes.
  2. Load and airflow check: we confirm how much air each room needs for the equipment you have or plan to install.
  3. Design: we plan the trunk, branches and returns, and decide what to keep, seal or replace.
  4. Written quote: you see the scope and price before any work starts.
  5. Removal and install: old ducts come out, new ducts go in, with joints sealed and runs supported.
  6. Insulation: ducts in unheated spaces get insulated wrap or insulated duct.
  7. Testing and balancing: we check airflow at the registers and adjust so rooms heat and cool evenly.

Most single-family homes take one to three days, depending on access and scope. Learn more on our duct installation services page.

Questions to ask any contractor

  • Will you seal every joint with mastic or approved tape, not cloth duct tape?
  • How will you insulate ducts in the crawl space or attic?
  • Will you measure airflow after the job?
  • Is a permit included where one is required?
  • Are you licensed and bonded in Washington? You can check any contractor on the state L&I website.

Ductwork Replacement Cost FAQs

How much does it cost to replace HVAC ducts?

Most whole-home duct replacements fall between about $2,000 and $12,000, with a national average near $4,000. Expect about $10 to $25 per linear foot for new ductwork, and more in tight crawl spaces. Home size, access, materials and design changes set the final price.

How often should you replace ductwork?

Well-installed ductwork can last for decades. Replace it when it is damaged, badly leaking, poorly insulated or sized wrong for your equipment. Many homes only need sealing or partial repairs. Have ducts inspected when you replace your furnace or heat pump.

Should I replace 20 year old ductwork?

Not just because of its age. Twenty-year-old ducts in good shape can keep working well. Have them inspected for leaks, damage, insulation and sizing. Replace sections that fail those checks, and seal the rest.

How hard is it to replace ductwork in a house?

It depends on access. Ducts in an open basement or garage are fairly easy to reach. Ducts in a crawl space, attic or inside finished walls are much harder and take longer. This is a job for a licensed HVAC contractor, not a weekend project.

How much does it cost to replace air ducts in a 1000 square foot house?

A small home needs fewer linear feet of duct, so it usually lands at the low end of the national range. Access still matters. A 1,000 square foot home with a tight crawl space can cost more than a larger home with an open basement. An inspection gives you a real number.

Get an Honest Ductwork Quote

You should not pay to replace ducts that only need sealing. Call Air Pro Solutions Heating, Cooling & Electrical at (253) 397-7220 and ask for a ductwork inspection. You will talk to Efer or Alec, the owners, not a call center. We will show you what we find, explain repair, seal or replace options, and give you a written price before work starts. We are open Monday to Friday, 7:30 AM to 8 PM, and serve Auburn, Kent, Bonney Lake HVAC contractor customers and nearby King and Pierce County. Or request a quote online.

Author Info

Efer Zamorano

Co-Owner & Lead HVAC Technician | Air Pro Solutions LLC

Efer Zamorano is the co-owner of Air Pro Solutions LLC, a licensed, bonded, and insured HVAC contractor serving South King County and the greater Seattle area. With 15+ years of hands-on experience across indoor air quality, climate control, and high-efficiency system design, Efer specializes in heat pump installations, Mitsubishi Hyper Heating systems, full system replacements, ductwork redesign, and retrofit solutions. Known for honest recommendations and technical precision (not sales tactics), Efer ensures every installation is fully commissioned and tested for peak performance delivering efficient, eco-friendly comfort homeowners can rely on.

Why Homeowners Trust Us

If we can’t fix it, you don’t pay